Added a compatibility mode with default redstone logic. It can be set via the plugin configuration under the key "redstoneCompatibility". If set to 'true', compatibility is enabled. By default, it is disabled.

Command usage: /logicgates redstonecompatibility <on|off>
Required permissions: logicgates.admin

In redstone compatibility mode, the plugin attempts to not only observe the power state of the block at the input of the logic gate but also to observe the direction of the block on the input wall of the gate.

For example:
In redstone compatibility mode:

• You cannot power the gate's input by placing a redstone torch next to it; the torch must be placed directly on the gate's wall.
• You cannot power the gate's input by placing a redstone circuit; the redstone must directly point to the gate's wall.
• You cannot power the gate's input by placing a repeater; it must directly point to the gate's wall.

Disabling redstone compatibility mode often allows for minimizing mechanisms, but these are not standard redstone behaviors in Minecraft.

Additionally:

• Added support for REDSTONE_BLOCK at the gate's input.
• Added a comparator to the invalid_output_material list.
• The gate's input can be powered by an activated REDSTONE_LAMP (breaks redstone rules).
• The gate's output can now directly connect to DOOR, TRAPDOOR, FENCE_GATE (opens/closes), REDSTONE_LAMP (powers), FURNACE, CAMPFIRE (changes ignition state), PISTON (buggy behavior).

The following keys were added to messages.yml:

• redstonecompatibility_usage
• redstonecompatibility_enabled
• redstonecompatibility_disabled
• redstonecompatibility_invalid_state